Alternator and steering work

vt_20161030_083934

This morning I started back in on attaching the new alternator.  First step was soldering in the fusible link.  The first wire on the right went really well,  The second one not so much.  The red wire is original to the car and the solder did not want to stick to the old dirty copper.  By the time I got it soldered it was a big mess and the shrink tube would not fit over it.  Rats.  I should un-solder the whole mess and start over but I am ready to wrap it in electrical tape and move on.

vt_20161030_090027

Looks pretty nice.  Then I realized I had not put the wires below the alternator back in the loom so I had to take it apart again and fix it.

vt_20161030_091604

So then I put it together and realized I forgot to tighten the bolt on the alternator bracket behind the coil.  So I took it apart again.  This time I put spacer washers in there to make everything line up better.  The red circles show where the washers are.

vt_20161030_093501

The mount is nice and tight, wires are loomed, and brackets lined up.  Then I realized I had the belt on the wrong pulley.  At least this time I did not have to take it apart completely.

vt_20161030_090045

I do NOT want to take this apart again.  But it looks good this time.  I checked the wiring and the ground on the alternator with a meter.

vt_20161030_105930

On my last parts store run I also picked up a ground strap.  I don’t see on on the engine so I figure better safe than sorry.  The plan is to use one of the holes in the frame where the snow plow used to mount for one end and a bolt on the engine for the other.  The hole in the frame is pretty big so I rigged up that stack of washers to make it work.  I nee.d the big long bolt because the frame is fully boxed.

So here is where the picture of the installed ground strap would go but that picture did not turn out well at all so we will just have to imagine it.

vt_20161030_095318

Speedometer cable time.  With the instrument cluster out of the way it pulls right out.

vt_20161030_095548

I wiped down the cable then fed it back in.  As I put it in I lubed it with cable lubricant.

vt_20161030_100325

Here is the transmission end of the speedometer cable.  I took it loose to make sure the cable got back into its hole correctly.  No problems I hope.

vt_20161030_120608

I still don’t have the bulb sockets for the instrument cluster so I moved on to the steering.  I took out the reach rod.  This comes out by removing the cotter pins and unscrewing the end caps until the socket is loose enough to pop off.  The sockets are pretty worn but I have a rebuild kit.

vt_20161030_112657

I removed the steering bell crank as well.  I removed the pinch bolt then the big pivot bolt.  I expected the bushing to be badly word but it is nice and tight.

vt_20161030_114549

I popped the tie rod end with my nifty tie-rod-end popper.

vt_20161030_121355

And we have tie rod ends.  I measured these and marked the positions of everything so I could put it back together like it came apart.  Then I settled in for a parts cleaning and painting party.  Then while the paint was drying it started to rain.  So the end  result was no pictures.  But I take some putting things back together tomorrow.

Leave a Reply

Your email address will not be published. Required fields are marked *